Outputs; Main Outputs; Individual Outputs - Korg M3 Parameter Manual

Outputs Main Outputs

Outputs

Main Outputs

The main L/MONO and R outputs of the M3 are output
from the AUDIO OUTPUT (MAIN) L/MONO and R jacks,
the S/P DIF OUT (MAIN) jack, and the headphone jack.

Individual Outputs

The M3 is equipped with four individual audio outputs,
which can be used as individual mono outputs, stereo pairs,
or any combination of the two. Almost any signal source can
be routed to these outputs, including:
• Each note in a Drum Kit
• Insert Effect outputs
• Each Program in a Combination or Song
• Audio inputs
You can use these to isolate or group together sounds for
recording, or for complex live performance setups.
If the signal is going through one or more insert effects, the
output is set at the last IFX in the chain, via the Bus Select
parameter on the P8– Insert FX Setup page.
If a Program, Timbre, or Track is not going through any
insert effects, the output is set using the Bus Select
parameters on the P8– Routing page.
To assign audio inputs directly to outputs, use Bus Select
parameters in the P0– Sampling/Audio In page.
In Global mode, the Audio page L/R Bus Indiv. Assign
(Assign to L/R and Indiv.Out) (Global 0–3b) setting lets you
mirror the MAIN stereo L/R output on any pair of
individual outputs. You can use this to create a private
monitoring setup in live and studio environments. For more
information, please see "0–3b: Output" on page 362.
Note: You can't use the VOLUME slider to adjust the volume
of the individual outputs.
437