008: St.exciter/Enhncr - Korg M3 Parameter Manual

Effect Guide
You can configure a 21-Band Graphic EQ ranging from 80
Hz to 18 kHz if you route three Graphic 7-Band EQ effects in
series, with a setting of 7:Low, 9:Mid, and 11:High for each
EQ.

008: St.Exciter/Enhncr

(Stereo Exciter/Enhancer)
This effect is a combination of the Exciter, which adds a
punch to the sound and the Enhancer, which adds spread
and presence.
Stereo In - Stereo Out
Left
LEQ HEQ
EQ Trim
EQ Trim
Right
D -mod
Exciter Blend –100...+100
a Src Off...Tempo
Amt –100...+100
Emphasis
0...70
Point
Src Off...Tempo
b
Amt –70...+70
Enhancer
c Delay L 0.0...50.0
[msec]
Enhancer
d Delay R 0.0...50.0
[msec]
Enhancer
0...100
Depth
e
Src Off...Tempo
Amt –100...+100
f EQ Trim 0...100
Low,
Pre LEQ Fc
Mid-Low
g
High,
Pre HEQ Fc
Mid-High
Pre LEQ Gain
–15.0...+15.0 Sets the gain of the Low EQ
[dB]
h
Pre HEQ Gain
–15.0...+15.0 Sets the gain of the High EQ
[dB]
Dry, 1 : 99...
Wet/Dry
99 : 1, Wet
i Src Off...Tempo
Amt –100...+100
a: Exciter Blend
This parameter sets the depth (intensity) of the Exciter effect.
Positive values give a frequency pattern (to be emphasized)
different from negative values.
b: Emphasis Point
This parameter sets the frequency to be emphasized. Higher
values will emphasize lower frequencies.
446
Exciter
Delay
Depth
Delay
Exciter
Enhancer
Sets the intensity (depth) of the
Exciter effect p.446
Selects the modulation source
of the Exciter intensity
Sets the modulation amount of
the Exciter intensity
Sets the frequency to be
emphasized p.446
Selects the modulation source
of the frequency to be empha-
sized
Sets the amount of modulation
of the frequency to be empha-
sized
Sets the delay time for the
Enhancer left channel p.446
Sets the delay time for the
Enhancer right channel p.446
Sets the determines to what
degree the Enhancer effect is
applied
Selects the modulation source
of the Enhancer width
Sets the modulation amount of
the Enhancer width
Sets the 2-band EQ input level
Selects the cutoff frequency
(low or mid-low) of the low-
range equalizer
Selects the cutoff frequency
(high or mid-high) of the high-
range equalizer
Sets the balance between the
effect and the dry input
Selects a modulation source for
Wet/Dry
Sets the modulation amount
for Wet/Dry
c: Enhancer Delay L [msec]
d: Enhancer Delay R [msec]
These parameters set the delay time for the Enhancer left
and right channel. Specifying a slightly different delay time
for the left and right channel will add a stereo image, depth,
and width to the sound.
Wet / Dry
Wet / Dry