Korg M3 Parameter Manual page 176

Combination mode
unrelated KARMA GEs one a time and use them in a song.
In this case, you do not usually want them to be connected
to each other.
Enable RTC (Enable RTC By Master):
A
B
C
D
Off (unchecked): If there are controls in the Master Layer
that are assigned to the specified Module, moving them or
changing scenes in the Master Layer will have no effect on
the Module's parameters.
This allows you to "disconnect" a Module Layer from the
Master and "freeze" its current sound (in conjunction with
turning Link Scenes To Master off.)
On (checked): If there are controls in the Master Layer that
are assigned to the specified Module, moving them or
changing scenes in the Master Layer will affect the
parameters and sound of the Module.
Note: In order to completely disconnect a Module from
alteration by the Master Layer ("freeze" its settings), you
need to uncheck both Link Scenes To Master and Enable
RTC By Master. If you only disable Link Scenes To Master,
the settings of the Master Scenes may still influence any
parameters that are hooked up to controls in both the Master
and Module Layers, depending on whether they were last
moved in the Master.
Of course, any Module's Real-Time Parameters that are only
assigned to controls in the Master Layer for that Module will
also be affected by the Master Scenes, unless Enable RTC By
Master is Off (unchecked).
When Enable RTC By Master is turned Off
(unchecked), any parameters that are assigned to
controls in both the Master and Module Layers may
change, because the values for the Module Layer will
be sent out for whatever scene is selected in the Module
Layer.
In other words, if Duration % (Gate) is assigned in both
layers to a Slider, and it was last moved in the Master
Layer, the GE will be playing with the Master Layer
duration setting. If you disconnect the Master Layer,
the duration value indicated by the Module Layer will
be sent out. You can adjust the Module Layer's
Duration % (Gate) control to sound the same at that
point, if desired.
Turning Enable RTC By Master back on will resend the
Master Layer's duration setting, if it was the last moved
control connected to the duration in that Master Scene.
DT Run (Drum Track Run) 1...8
This turns drum track muting on/off for each Master scene.
When KARMA is Off, the drum track is not affected by this
setting. When you turn DRUM TRACK ON/OFF On, the
drum track will operate and sound according to the Trigger
Mode setting.
When KARMA is On, the drum track will be muted (silent)
when you select a Master scene in which DT Run is Off,
even though the drum track had been operating. When you
select a Master scene in which DT Run is On, muting will be
turned off (the drum track will sound).
On (checked): When DRUM TRACK ON/OFF is On, the
drum track will operating according to the Trigger Mode
setting, and its muting will be off (i.e., it will sound).
Off (unchecked): For Master scenes in which this is Off, the
drum track will be muted (silent) even if it had been
operating.
166
▼7–1–7: Menu Command
• 0: Write Combination ☞p.185
• 1: Panel–SW Solo Mode On ☞p.106
• 2: Exclusive Solo ☞p.107
[Off, On]
• 3: Copy KARMA Module ☞p.114
[Off, On]
• 4: Initialize KARMA Module ☞p.115
[Off, On] • 5: Copy Scene ☞p.115
• 6: Swap Scene ☞p.115
[Off, On]
• 7: Capture Random Seed ☞p.116
• 8: Copy from Program ☞p.185
For more information, please see "Combination: Menu
Command" on page 185.
[Off, On]