Korg M3 Parameter Manual page 227

SEQ P1: DT/XY/Ctrls 1–2: X–Y Vol T01–08, 1–3: X–Y Vol T09–16 (X–Y Volume Control T01–08, T09–16)
Off (unchecked): X–Y position will not affect the volume.
However, you can use program parameter settings for X–Y
CC or AMS to control the volume.
Equal Amount
This applies only when Enable Volume Control is On.
When Equal Amount is On, the X–Y will fade between all
four X–Y axes while maintaining a total amount of 100%.
This provides a smooth fade between the different sounds,
and is the type of volume control used by classic vector
synths.
Note that this will work best when the Programs assigned to
each of the four axes have equivalent volumes. For instance,
X–Y Synthesis system, Sequencer mode
Sequencer
X–Y Control
MIDI In
(Global Chan.)
Front panel X–Y control will control the MIDI track specified by
"Track Select" if it is set to the global MIDI channel.
X–Y motion
X–Y Control
Track 1
Front panel X–Y control will control tracks of the same
MIDI channel as "Track Select."
X–Y Control
MIDI In
(Track Chan.)
[Off, On]
SEQ X–Y Volume Control
Track 1–16 Center Volume
and Equal Power settings
SEQ X–Y CC Control
X Mode and
Y Modes
X–Y CC MIDI Output
Global Controllers
MIDI CC Assignments
Defaults: X=118, Y=119
Program X–Y Volume Control
Osc 1–2 Center Volume
and Equal Power settings
Program X–Y CC Control
X Mode and X+/– and Y+/–
Y Modes CC Assignments
you might create a Song with four Programs, each sounding
at the same volume and assigned to a different axis. You
could then add a fifth Program, assign it to one of the axes,
and then reduce the volumes of both Programs on that axis
by 50%–so that their combined volume is the same as any
one of the other Programs.
Also, when this is checked, the Center Volume parameters
will be grayed out, since Equal Amount sets them
automatically.
When Equal Amount is Off, the individual Track Center
Volume parameters determine the way in which X–Y
position affects volume.
SEQ switch:
"Enable Volume control"
SEQ switch:
"Enable CC control"
X+/– and Y+/–
CC Assignments
Global switch:
"X–Y MIDI Out"
X–Y CC Control
X–Y Control
* Depending on the MIDI I/O settings of the KARMA module,
tracks other than the "Track Select" MIDI channel will also be
controlled.
Program switch:
"Enable Volume control"
Program switch:
"Enable CC control"
X–Y Modulation of
Track Volume
X–Y CC Modulation of
Program and FX Parameters
(Global Channel Only)
X–Y CC MIDI Output
X–Y Modulation of
Osc 1–2 Volume
X–Y CC Modulation of
Program Parameters
Track 16
217