Sampling Page Select - Korg M3 Parameter Manual

Sampling mode

Sampling Page Select

• Press the MODE SAMPLING switch to select Sampling
mode.
You can use the following ways to select the pages in
Sampling mode.
1. Press the PAGE SELECT switch to access "Page Select."
"Page Select" shows an abbreviated name for each page.
The page in which you were prior to pressing the PAGE
SELECT switch is shown in light blue.
2. Select the desired page in the display.
Other ways to select pages
• Hold down the PAGE SELECT switch and press a
numeric keys 0–9 to specify a page number; you will
move to the corresponding page.
For example if you want to access the P3: Multisample
page, hold down the PAGE SELECT switch and press
numeric key 3.
Note: For pages that consist of multiple subpages, such as
P0–1 and P0–2 or P8–1 and P8–2, the first of these pages
(P0–1 or P8–1) will be selected.
• You can press the EXIT switch to return to the P0:
Recoding page you selected most recently. Press the
EXIT switch once again to return to the Main page.
300
Page
Record (sample) a sample. Select the sample
or multisample to be recorded, make
P0: Recording detailed settings for recording, make AUDIO
INPUT settings, and view the memory status.
(☞p.301)
Sample, or edit the waveform etc. of samples
P1: Sample Edit you loaded into internal memory using
Media mode. (☞p.313)
Set playback parameters for samples, such as
start, loop start, end address, loop on/off,
P2: Loop Edit and reverse playback on/off. Perform editing
operations such as Time Slice and Time
Stretch. (☞p.315)
Edit multisamples. Edit settings such as
P3: Multisample sample assignments, zones, and original key.
(☞p.317)
P4: Controllers
Controller settings. (☞p.319)
Setup
P5: Audio CD Play back or rip from an audio CD. (☞p.321)
Bus and master effect send level settings.
P8: IFX Insert effect routing, selection, and settings.
(☞p.323)
Master effect routing, selection, and settings.
P9: MFX/TFX
Total effect selection and settings. (☞p.327)
Main content