005: Stereo Gate - Korg M3 Parameter Manual

Effect Guide

005: Stereo Gate

This effect mutes the input signal when it falls below a
specified level. You can also invert the on/off status of the
gate, or use note-on/off messages to turn the gate on/off
directly.
Stereo In - Stereo Out
Left
Envelope Source
Side PEQ
+
Envelope Select
D -mod
Right
FX Control BUS 1
FX Control BUS 2
D-mod,
Envelope Input,
Source FX Control 1,
a
FX Control 2
Fx Ctrl Trim 0...100
L/R Mix,
Envelope
L Only,
Select
R Only
b
Src Off...Tempo
Threshold 0...100
c
Polarity +, –
Attack 1...100
d
Release 1...100
Delay Time
e 0...100
[msec]
Side PEQ
Off, On
Insert
f
Trigger
Off, On
Monitor
Side PEQ
20...12.00k
Cutoff [Hz]
g
Q 0.5...10.0
Gain [dB] –18.0...+18.0
Dry, 1 : 99...
Wet/Dry
99 : 1, Wet
h Src Off...Tempo
Amt –100...+100
c: Threshold
d: Attack
d: Release
Threshold specifies the level at which gating occurs when
Envelope Select is set to L/R Mix, L Only, or R Only.
Attack and Release specify the attack time and release time
of the gate.
444
Wet / Dry
Gain Adjust
Delay Gate
Envelope - Control
Trigger Monitor
Envelope - Control
Delay Gate
Gain Adjust
Wet / Dry
Selects the source to control
the gate: D-mod control, or use
the input signal or FX Control
Bus 1 or 2 as a trigger
p.442
Sets the trigger input level from
FX Control Bus 1/2
Selects the control signal: left
and right linked, left only, or
right only p.442
Selects the source that will
control the gate when
Envelope Src = D-mod
Sets the level at which gating is
applied p.444
Switches the polarity of gating
p.444
Sets the attack time p.444
Sets the release time p.444
Sets the delay time for the gate
input p.444
Switches the trigger signal
equalizer on/off p.442
Switches between monitoring
the effect output and the
trigger signal p.442
Sets the center frequency of
the equalizer for the trigger
signal p.442
Sets the bandwidth of the
equalizer for the trigger signal
p.442
Sets the gain of the equalizer
for the trigger signal p.442
Sets the balance between the
effect and the dry input
Selects a modulation source for
Wet/Dry
Sets the modulation amount
for Wet/Dry
Output Level
Threshold
Dry
Wet
Wet
Attack
c: Polarity
This inverts the polarity of the gate on/off operation. With
the "–" setting, the gate will close when the input signal
exceeds the specified level. The direction in which the
modulation source opens or closes the gate will also be
reversed.
e: Delay Time [msec]
This sets the delay time for the input to the gate. When using
shorter Attack Time settings, you can lengthen the Delay
Time so that the sound is input after the gate opens.
Gate - Threshold
Louder
Input Level
Gate - Attack / Release
Threshold
Attack=1
Release=1
Attack=100
Release=100
Release