Parameters Controlled By Midi Ccs #70-79 - Korg M3 Parameter Manual

Parameters controlled by MIDI
CCs #70-79
In Program mode, when CC#70–79 is received on the global
MIDI channel, or when a Realtime Control Slider 1–4 is
operated in Realtime Control Slider 5–8 when the function is
assigned to CC#70–79, the corresponding Program
parameter(s) will be edited temporarily.
CC#
70 (Sustain level)
71 (Filter resonance)
72 (Release time)
73 (Attack time)
74 (Filter cutoff frequency)
75 (Decay time)
76 (LFO1 speed)
77 (LFO1 Pitch intensity)
78 (LFO1 delay)
79 (Filter EG intensity)
M3 and MIDI CCs Parameters controlled by MIDI CCs #70-79
Internal parameters controlled by the CC
Filter EG 1/2 Sustain (see page 54)
Amp EG 1/2 Sustain (see page 62)
Filter A/B, 1/2 Resonance (see page 48)
Filter EG 1/2 Release (see page 54)
Amp EG 1/2 Release (see page 62)
EG Times:
Filter EG 1/2 Attack (see page 54)
Amp EG 1/2 Attack (see page 62)
Amp EG 1/2 Time Modulation: Attack (see page 63)
EG Levels:
Amp EG 1/2 Level Start (see page 62)
Amp EG 1/2 Level Attack (see page 62)
Amp EG 1/2 Level Modulation: Start (see page 63)
Filter A/B, 1/2 Frequency (see page 48)
Filter EG 1/2 Decay (see page 55)
Filter EG 1/2 Slope (see page 55)
Amp EG 1/2 Decay (see page 62)
Amp EG 1/2 Slope (see page 62)
LFO 1 Frequency (see page 66)
Pitch LFO1 Intensity (see page 41)
LFO 1 Delay (see page 67)
Filter EG 1/2 Intensity to A (see page 52)
Filter EG 1/2 Intensity to B (see page 52)
In most cases, you can use the Write Program menu
command to save the edited values, over-writing the
previous Program settings.
In Sampling mode, these CCs will temporarily edit the
Program parameters, just as in Program mode. You can use
Convert MS to Program menu command to save that state
as a program (except for some parameters).
In Combination and Sequencer modes, you can use
these CCs to temporarily edit the parameters for all
Timbres or Tracks on a given MIDI channel. However,
edits made in this way cannot be saved back into a
Program.
613