8-2-8: Common Fx Lfo - Korg M3 Parameter Manual

Combination mode
8–2–8: Common FX LFO
8–2
–8a
8–2
–8b
The two Common FX LFOs allow you to synchronize LFO-
based modulation for multiple effects, such as phasers,
flangers, filters, and so on.
The Common LFOs control only the frequency, MIDI
synchronization, and reset options; each individual effect
still has its own settings for the LFO waveform and phase.
Within the individual effects, you can choose whether to use
one of the Common LFOs, or to use the individual effect's
frequency, sync, and/or reset settings instead. This is done
via the effect's LFO Type parameter; select Individual to use
the effect's settings, or Common 1 or 2 to use the Common
LFOs.
8–2–8a: Common FX LFO1
Ctrl Ch (Control Channel)
Specifies the MIDI channel that will control dynamic
modulation (Dmod) for Common LFO 1 and 2.
G ch: The global MIDI channel (Global 1–1a) will be used
for control. This is the default.
Sync (Reset)
Source (Dmod Source)
Frequency
MIDI/Tempo Sync
BPM
Base Note
Times
These parameters are the same as in Program mode. For
more information, please see "8–8: Common FX LFO" on
page 102.
8–2–8b: Common FX LFO2
These parameters are the same as for Common FX LFO1.
▼8–2–8: Menu Command
• 0: Write Combination ☞p.185
• 1: Panel–SW Solo Mode On ☞p.106
• 2: Exclusive Solo ☞p.107
• 3: Copy Insert Effect ☞p.117
• 4: Swap Insert Effect ☞p.118
For more information, please see "Combination: Menu
Command" on page 185.
182
8–2
–8
Menu
[Ch01...Ch16, G ch]
[Off, On]
[List of Dmod Sources]
[0.02...20.00 (Hz)]
[Off, On]
[MIDI, 40.00...300.00]
3 3 3 3
[ , , , , , , , , , ]
[01...32]