Korg M3 Parameter Manual page 393

Change all bank references
This command changes all program banks specified for
timbres in combinations or tracks of songs.
1. Select "Change all bank references" to open the dialog
box.
2. If you wish to change bank references for combina-
tions, check Combination.
If you wish to change bank references for songs, check Song.
3. In Program Bank, specify the replacement for each
bank.
4. To execute the Change All Bank References command,
press the OK button. To cancel, press the Cancel button.
If you change two or more different banks to the same
bank, it will not be possible to use this function to
change them back to different banks. Be careful that the
change destination banks do not overlap.
Touch Panel Calibration
If input via the display does not work as you expect, or if the
edit cell moves to a location other than where you pressed
the display, use this command to adjust the sensitivity of the
display.
1. Select "Touch Panel Calibration" to open the dialog
box.
2. If you are unable to select this command from the
menu, go to the main Global page as normal, and then
hold down the ENTER button and press 4 on the
numeric keypad. This will call up the calibration dia-
log.
3. Press the square in the upper left of the display. When
your touch has been detected correctly the square will
be highlighted.
4. Press the square in the lower right of the display. When
your touch has been detected correctly the square will
be highlighted.
5. Press the Done button.
If your touch was not detected correctly, an error message
will appear. Please perform the procedure once again.
Global: Menu Command Change all bank references
Half Damper Calibration
If a damper pedal that supports half damper (the DS–1H
option) is connected to the DAMPER jack, here's how you
can adjust the sensitivity if the damper effect is not applied
appropriately.
Since the half-damper pedal is highly sensitive, please
use the optional DS–1H. Other pedals may not produce
the appropriate effect, or may be impossible to calibrate
correctly.
1. Connect a half-damper pedal to the DAMPER jack.
2. Select "Half Damper Calibration" to open the dialog
box.
3. Press the half-damper pedal, and then release your foot
from the pedal.
4. Press the Done button.
If the adjustment could not be performed correctly, an error
message will be displayed. Please perform the procedure
once again.
Pad Calibration
This adjusts the velocity sensitivity of the pads.
1. Select "Pad Calibration" to open the dialog box.
2. Press the center of each pad as lightly as possible.
3. Press the Done button.
If the calibration could not be performed correctly, an error
message will appear. Please perform the procedure again.
After Touch Calibration
You can adjust the aftertouch sensitivity of M3 (KYBD-61/
73/88) keyboard.
When this instrument is shipped from the factory, the
aftertouch sensitivity is adjusted to a standard value. In
normal use, you won't need to perform this calibration
again.
However, you may customize the aftertouch sensitivity as
described below. Try this if you want the aftertouch to be a
bit lighter. Play the keyboard from the same position as
when you're actually performing, so that you can adjust the
sensitivity ideally for your own playing style.
1. Slowly depress any note and verify that the bar indica-
tor moves from left to right.
383