Korg M3 Parameter Manual page 71

4–2b: Amp Modulation
You can modulate the Amp level by both velocity and an
AMS source.
This modulation scales the basic Amp level and Amp EG
level parameters. The resulting volume is determined by
multiplying the volume changes of the amp EG by other
values such as AMS. If these original levels are low, the
maximum volume available with modulation will also be
reduced.
Velocity Intensity
With positive (+) values, the volume will increase as you
play harder.
With negative (–) values, the volume will decrease as you
play harder.
Velocity modulation of Amp level, with Amp EG
Volume
Time
Low velocity
AMS
This selects any AMS modulation source to control the
Amp1 level. For a list of AMS sources, please see "AMS
(Alternate Modulation Source) List" on page 588.
Intensity
This controls the depth and direction of the modulation.
For example, if AMS is set to After Touch, positive (+)
values of this parameter will make the volume increase
when you press down on the keyboard.
Note that if the other modulation settings have already
raised the volume to its maximum level (double the Amp
Level and Amp EG level settings), the volume cannot be
increased any further.
With negative (–) values of this parameter, the volume will
decrease when pressure is applied to the keyboard.
LFO 1/2
You can modulate the Amp level with both LFO1 and LFO2.
LFO1
Intensity (LFO1)
This controls the depth and direction of LFO1's effect on the
oscillator's volume.
Negative (–) values will invert the LFO waveform.
AMS (LFO1)
This selects an AMS modulation source to scale the amount
of the LFO1 applied to the Amp level.
For a list of AMS sources, please see "AMS (Alternate
Modulation Source) List" on page 588.
Intensity
This controls the depth and direction of the LFO1 AMS
modulation for the Amp level.
For example, if AMS (LFO1) is set to After Touch, positive
settings mean that aftertouch will increase the amount of
LFO1 applied to the Amp level.
LFO2
The parameters for LFO2 are identical to those for LFO1. For
more information, please see the descriptions under LFO1,
above.
[–99...+99]
Time
High velocity
[List of AMS Sources]
[–99...+99]
[–99...+99]
[List of AMS Sources]
[–99...+99]
PROG P4: Amp/EQ 4–2: Amp1 Modulation
▼4–2: Menu Command
• 0: Write Program ☞p.106
• 1: Panel–SW Solo Mode On ☞p.106
• 2: Exclusive Solo ☞p.107
• 3: Copy Oscillator ☞p.111
• 4: Swap Oscillator ☞p.111
For more information, please see "Program: Menu
Command" on page 106.
61