Korg M3 Parameter Manual page 122

Program mode
Copy Drum Track
Copy Drum Track is available on the DrumTrk Pattern tab
or DrumTrk Program tab of the Basic/DT/Ctrls.
This command copies settings from the specified program,
combination/timbre, or song.
1. Select "Copy Drum Track" to open the dialog box.
2. Use the From field to select the mode, bank, and
number of the desired copy-source. You can press a
BANK switch to select the desired bank.
3. If you execute this command in Program mode, and
select Program in From, the additional field Program
Settings too will appear.
On (checked): The parameter settings of the Drum Track
Pattern page and Drum Track Program page will be copied.
Off (unchecked): The parameter settings of the Drum Track
Pattern page will be copied.
If you execute this command in Combination or Sequencer
mode, the parameter settings of the Drum Track Program
page will be copied. However, the MIDI Channel setting
will not be copied.
4. To execute the Copy Drum Track command, press the
OK button. To cancel, press the Cancel button.
Erase Drum Track Pattern
Erase Drum Track is available on the DrumTrk Pattern tab
or DrumTrk Program tab of the Basic/DT/Ctrls.
This erases the drum track pattern you specify.
1. Select "Erase Drum Track Pattern" to open the dialog
box.
2. Select the user drum track pattern you want to erase.
3. If you check All Drum Track Patterns, all user drum
track patterns will be erased.
4. To execute the Erase Drum Track Pattern command,
press the OK button. To cancel, press the Cancel button.
112
Copy Pad Setup
Copy Pad Setup is available on the Pads 1–4 Setup or Pads
5–8 Setup of Basic/DT/Ctrls page.
This command copies the pad settings of the specified
Program, Combination, or Song.
1. Select "Copy Pad Setup" to open the dialog box.
2. Use the From field to select the mode, bank, and
number of the desired copy-source. You can also select
Banks via the front-panel BANK SELECT switches.
3. Select the copy-source pad number. If you want to copy
all settings for pads 1–8, check the All option.
4. Use the To field to specify the copy-destination pad.
Note: Executing this command will copy the note number
and velocity value. The MIDI channel is not copied.
5. To execute the Copy Pad Setup command, press the OK
button. To cancel, press the Cancel button.
Sample Parameters
Sample Parameters is available on the OSC 1/2 Basic pages.
This command lets you adjust various parameters for the
individual samples within a RAM multisample, including
volume level, cutoff, resonance, pitch, EG attack and decay,
drive and low boost, and EQ gains.
The Sample Parameters command is available only if you've
selected a RAM Multisample; it is not available for ROM
Multisamples, or Drum Kits.
When you've finished editing the parameters, press the
Done button. Please note that Compare is not available for
edits made in this dialog box.
Note: The Sample Parameters settings apply everywhere
that the Multisample is used, and not just to the current
Program. If another Program uses the same Multisample, it
will also be affected by any changes that you make here.
Index
An Index is a key zone in a Multisample, including a single
Sample and all of its associated parameters. This is the
currently selected Index.
[001...128]