Mode - Korg M3 Parameter Manual

System Exclusive events supported in Sequencer mode
You can record and play back System Exclusive events, and edit tracks that contain System Exclusive events.
SysEx messages that can be recorded in real-time
The following exclusive messages can be recorded in real-time:
• Exclusive messages received from an external MIDI device
• Parameter changes in Sequencer mode (see table below)
• Master Volume universal exclusive messages assigned to the foot pedal or a slider
Parameter change messages that you can realtime-record in Sequencer mode
Front panel/Page
KARMA
Front panel
Control Surface
Program, Mixer
Sampling/Audio In
P0: Play/REC
Control Surface
X–Y Vol
X–Y CC
P1: DT/XY/Ctrls
Controllers Setup
Pads Setup
P2: EQ/Option EQ Trim
MIDI
P3: Track Param OSC
Pitch
P4: Zone/Delay Delay
GE Setup
P7: KARMA
Note Map
Routing1/2
Insert FX
P8: IFX
IFX 1–5
Common FX LFO
Routing
P9: MFX/TFX
MFX 1/2
TFX
*1: Solo On/Off is always controlled by events in the track,
regardless of the play/mute status of that track.
The maximum amount of exclusive data that can be
recorded at once is approximately 320 Kbytes. This size
will decrease if other events exist within the same
measure.
You cannot simultaneously record exclusive messages
received from an external MIDI device and parameter
changes produced by editing.
The events that will be recorded are controlled by the
Global P1: MIDI– MIDI Basic settings SEQ Mode
Param. MIDI Out. For Control Change, only control
change messages will be recorded. For SysEX-Param
Change, only parameter changes and exclusive
messages will be recorded.
System Exclusive events supported in Sequencer mode Copy Song
ON/OFF, LATCH, MODULE CONTROL switches
CONTROL ASSIGN, PAD MODE switches
Program Select, Pan, Volume, PLAY/MUTE, Solo On/Off
All "Audio Input" parameters
All "MIXER," "RT CONTROL," "KARMA SCENE," "KARMA Switch," "KARMA Slider" parameters, "TONE ADJ."
– Assign, Value
All "X–Y Volume Control" parameters, X–Y Assign, Center Volume, Enable Program X–Y Volume
All "X–Y CC Control" parameters, Enable Seq X–Y CC, Enable Program X–Y CC
All "Panel Switch Assign," "Realtime Control Slider Assign" parameters
All "Pads Chord" parameters
Auto Load Prog EQ, Bypass, Input Trim, High Gain, Mid Frequency, Mid Gain, Low Gain
Force OSC Mode, OSC Select, Portamento
Transpose, Detune, Bend Range, Other
Mode, Time, Base Note, Times
Load GEOptions
All parameters except "Octave Replicate"
Bus Select, Send1, Send2, Fx Control Bus, AUX Bus
IFX, IFX On/Off, Chain to, Chain, Pan, Bus Sel, AUX Bus, Ctrl Bus, Send1, Send2
All effect parameters
All "Common FX LFO 1, 2" parameters
MFX, MFX On/Off, Chain, Chain Direction, Chain Level, Return 1, Return 2, TFX, TFX On/Off, Master
Volume
All effect parameters
All effect parameters
Parameter
*1
295