Sw1/2 Assignments - Korg M3 Parameter Manual

Foot Switch (CC#82)
You can use this general-purpose controller as an AMS or
Dmod source. Note that you'll also need to assign FootSW
(CC#82) to control the desired parameter within the
Program or Effect.
MIDI #83 (CC#83)
You can use this general-purpose controller as an AMS or
Dmod source. Note that you'll also need to assign MIDI
CC#83 to control the desired parameter within the Program
or Effect.
MFX Send 1 & 2 (CC#s 93 & 91)
These control the send levels to Master Effects 1 and 2,
respectively.
CC#s 93 and 91 actually control send levels in two different
places: the sends directly from the Program OSC or
RADIAS, and the send levels of the last Insert Effect in the
chain which matches the CC's MIDI channel.
MIDI CC#00–95 and 102–119
These settings let you transmit any MIDI CC, except for
registered and non-registered parameters (CCs 96-101). If
you choose a CC which is used by AMS, Dmod, or the
standard CC routings, then it will affect the corresponding
M3 parameters.

SW1/2 Assignments

Switch assignments are saved separately with each
Program, Combination, and Song. In Sampling mode,
assignments apply to the entire mode. For more
information, see:
• Programs: "1–6: Controllers Setup" on page 35
• Combinations: "1–6: Controllers Setup" on page 144
• Sequencer mode: "1–6: Controllers Setup" on page 221
• Sampling mode: "4–1: Setup" on page 319
List of SW 1/2 assignments
The following functions can be assigned to SW1 and SW2.
Off
This setting disables the switch.
SW1 Mod. (CC#80) (SW1 Modulation: CC#80)
SW2 Mod. (CC#81) (SW2 Modulation: CC#81)
This lets you use the switch as an AMS or Dmod source.
Note that you'll also need to assign SW1 Mod or SW2 Mod
to control the desired parameter within the Program or
Effect.
Each time the switch is turned on or off, it transmits the
corresponding MIDI CC (80 or 81); Off is 0, and On is 127.
Porta.SW (CC#65) (Portamento SW: CC#65)
This turns Portamento on and off. When the LED is lit,
Portamento is on.
Each time the switch is turned on or off, it transmits MIDI
CC#65; Off is 0, and On is 127.
With single Programs, this simply enables and disables
Portamento, regardless of the of the Program's stored
Portamento Enable setting.
With double Programs, it's slightly more complex. If
Portamento is either enabled for both OSC 1 and 2, or off for
both, then the Portamento Switch controls both OSC.
If Portamento is enabled for only one of the two, only that
element will be affected by the switch; for the other element,
Portamento will always be off.
Controller Assignments SW1/2 Assignments
Octave Down
When the switch is on (LED lit), the pitch will be transposed
down by one octave.
Octave Up
When the switch is on (LED lit), the pitch will be transposed
up by one octave.
Lock functions
The Lock functions let you use SW1 or SW2 to "lock" the
current position of the joystick or ribbon controller, or the
current aftertouch value. This leaves your hands free to play
on the keyboard, or to use other controllers.
For instance, let's say that JS+Y is assigned to create a filter
sweep, and that SW2 is assigned to JS+Y Lock. You can then:
1. Move the joystick to open up the filter.
2. Press SW2 to turn on JS+Y Lock.
3. Release the joystick.
Since SW2 is locking JS+Y, the filter remains open, even
though the joystick has physically snapped back to its center
position.
Note that Lock affects only the physical controls. Even if
Lock is On, incoming MIDI messages can still change the
joystick, ribbon, and aftertouch values.
For more information, please see "Using the Lock function"
on page 41 of the Operation Guide.
JS X Lock
Locks the effect of the joystick X axis.
JS Y Lock
Locks the effect of the joystick Y axis (both + and –
directions).
JS+Y Lock
Locks the effect of the joystick +Y direction.
JS–Y Lock
Locks the effect of the joystick –Y direction.
Ribbon Lock
Locks the effect of the ribbon controller.
JS X & Ribbon Lock
Simultaneously locks the effects of the joystick X direction
and the ribbon controller.
JS Y & Ribbon Lock
Simultaneously locks the effects of the joystick Y direction
and the ribbon controller.
JS+Y & Ribbon Lock
Simultaneously locks the effects of the joystick +Y direction
and the ribbon controller.
JS–Y & Ribbon Lock
Simultaneously locks the effects of the joystick –Y direction
and the ribbon controller.
After Touch Lock
Locks the effect of aftertouch.
597