011: St. Vintage Wah - Korg M3 Parameter Manual

Effect Guide
a: Frequency Bottom
a: Frequency Top
The sweep width and direction of the wah filter are
determined by the Frequency Top and Frequency Bottom
settings.
Frequency
Top=75
Woo
Bottom=25
Higher
Zero
Frequency
Wah
Top=75
Woo
Bottom=25
Envelope
b: Sweep Mode
This parameter changes the wah control mode. Setting
Sweep Mode to Auto will select an auto-wah that sweeps
according to envelope changes in the input signal level.
Auto-wah is frequently used for funk guitar parts and clav
sounds.
When Sweep Mode is set to D-mod, you can control the
filter directly via the modulation source in the same way as a
wah pedal.
When Sweep Mode is set to LFO, the effect uses LFO to
sweep in cycle.
c: Envelope Sens
This parameter sets the sensitivity of auto-wah. Increase the
value if the input signal is too low to sweep. Reduce the
value if the input signal is so high that the filter is stopped
temporarily.
c: Envelope Shape
This parameter determines the sweep curve for auto-wah.
Level
d: LFO Frequency [Hz]
e: MIDI Sync
When MIDI Sync=Off, the LFO speed uses the LFO
Frequency parameter setting. When MIDI Sync=On, the
LFO speed follows the BPM, Base Note, and Times settings.
e: BPM
e: Base Note
e: Times
One cycle of LFO sweep is obtained by multiplying the
length of a note ( ... ) (selected for Base Note, in relation to
the tempo specified in BPM, or the MIDI Clock tempo if
BPM is set to MIDI) by the number specified in the Times
parameter.
448
Sweep Mode=D-mod
Frequency
Wah
Bottom=60
Wah
Woo
Top=30
D -mod
Higher
Max Zero
Sweep Mode=Auto
Frequency
Wah
Bottom=75
Woo
Top=25
Woo
Time Envelope
Envelope Shape
Envelope
value = 0...+100
value = 0...–100
Time
f: LFO Type
f: CmnLFO Offset [deg]
If Type is set to Common 1 or Common 2, modulation will
be applied using the Common FX LFO rather than the LFO
within the effect itself. Since this lets you use the same LFO
for multiple effects, it's useful when you want to apply
various types of modulation in synchronization.
CmnLFO Offset specifies the phase difference relative to the
Common FX LFO. For more information, please see
"Common FX LFOs" on page 423.
D -mod
Max

011: St. Vintage Wah

(Stereo Vintage/Custom Wah)
Wah
This effect simulates the tonal character of a vintage wah
Envelope
pedal. You can customize the tone and range settings.
Stereo In - Stereo Out
Left
Time
Envelope Sens
+
Right
Mode
a Shape
Invert
Frequency
Bottom
b
Frequency
Top
Resonance
Bottom
c
Resonance
Top
Sweep Mode
d Src
Manual
Envelope
Sens
e
Response
LFO
Frequency
[Hz]
f
Src
Amt
MIDI Sync
BPM
g
Base Note
Times
Wah
Sweep Mode
Shape / Invert
Auto
Response
D-mod
D -mod
LFO
LFO
Wah
Preset, Selects either preset or custom
Custom settings
Sets the curve of the sweep
–100...+100
Inverts the polarity of the
Off, On
sweep
Sets the lower limit of the wah
0...100 center frequency when Mode =
Custom
Sets the upper limit of the wah
0...100 center frequency when Mode =
Custom
Sets the lower limit of
0...100 resonance amount when
Mode=Custom
Sets the upper limit of
0...100 resonance amount when
Mode=Custom
Auto, Selects the control from auto-
D-mod, wah, modulation source, and
LFO LFO
Selects the modulation source
Off...Tempo for the wah when Sweep
Mode=D-mod
Sets the center frequency when
0...100 Sweep Mode=D-mod and
Source=Off
0...100 Sets the auto-wah sensitivity
Sets the speed of response
0...100 when Sweep Mode=Auto or D-
mod
0.02...20.00 Sets the speed of the LFO p.448
Selects a modulation source for
Off...Tempo
LFO speed
–20.00... Sets the modulation amount of
+20.00 LFO speed
When this is on, the LFO speed
is set by BPM, Base Note, and
Off, On
Times, instead of Frequency
MIDI syncs to the system
MIDI,
tempo; 40–300 sets the tempo
40.00...
manually for this individual
300.00
effect
Selects the type of notes that
...
specify the LFO speed
Sets the number of notes that
x1...x32
specify the LFO speed
Wet / Dry
Mode
Preset Setting
Custom Parameters
Wet / Dry
p.449
p.449
p.449
p.449
p.449
p.449
p.448
p.448
p.448
p.448
p.448