II. Getting Started
Installing the i2004 Internet Telephone
Before installing your i2004 Internet Telephone, consult your system
administrator to avoid serious damage to the set.
Your system administrator must create a terminal profile and provide you with an
IP address and other information required to initialize the set. Be sure you have
this information before installation:
• You will need the primary Directory Number or DNKey
• You will need to know whether your system uses full, partial or no DHCP
• If your system does not use full DHCP, you will need the parameter
information listed in the table on page 14.
Connecting the i2004 Internet Telephone
CAUTION – Severe damage will occur if this set is plugged into an ISDN
connection. Consult your system administrator to assure that you are plugging
your set into a 10/100 BaseT Ethernet jack.
To connect the i2004 Internet Telephone, follow these steps:
Step 1: Connect one end of the handset cord to the handset jack
on the telephone base, and connect the other end of the handset
cord to the handset.
Step 2: Connect one end of the line cord to the line cord jack on
the telephone base and the other end of the line cord to an IP voice
network, using a CAT-5 cable with an RJ45 connector.
Step 3: Plug the AC Power adapter into the base of the telephone,
and plug the adapter into the nearest 120V AC (60 Hz) outlet.
i2004 Internet Telephone - User Guide • © 2001 • NTC51.01.03.06 • Version 06-1
Page 11