Oki IP-6620 Maintenance Manual page 364

5.
Disconnect the X-MOTOR-ASSY cable
connector.
6.
Remove the two screws (refer to the
photo at the bottom in step 4) securing
the PLATE(X-MOTOR), and remove the
PLATE(X-MOTOR) and the
X-MOTOR-ASSY (with PINION) (refer to
the photo in step 7).
Note for installation
Install the X-MOTOR-ASSY with the cable
connector facing down.
7.
From the PLATE(X-MOTOR) removed in
step 6, remove the
X-MOTOR-ASSY(with PINION) with
fixing four screws.
Notes for installation
Required tools:
- Torque driver
- Fan-shaped tension gauge (0.1 to 20N),
double-side type
Manufacturer: Oba Keiki Seisakusho
Tighten the screws (1) and (2) to the torque of
1.5 N･m (153kg・cm). At this time, the gear
teeth do not contact yet.
OKI Data Infotech Corporation CONFIDENTIAL
Chapter 6 Parts Replacement (Disassembly/Reassembly)
SHAFT-X-PULLEY
X-MOTOR-ASSY (with PINION)
X-MOTOR-ASSY(with PINION)
(1)
(2)
X-MOTOR-ASSY
cable connector
PLATE(X-MOTOR)
6-35