Oki IP-6620 Maintenance Manual page 110

(4) PRIME 1 INK COLOR
Note
Before performing this procedure, open the COVER(CENTER)-F and remove the
COVER(R)ASSY-MW (see 6.3.2).
If you start the procedure before removing the COVER(R)ASSY-MW, you will have to performed
the procedure again with the COVER(R)ASSY-MW removed after finishing it once by opening the
COVER(CENTER)-F.
Select PRIME 1 INK COLOR with the Up and Down buttons, and then press the OK button.
>PH MAINTENANCE
 PRIME 1 INK COLOR
>>PRIME 1 INK COLOR
 PRINT HEAD : 1234567
Move the cursor with the Right and Left buttons, and toggle a digit with the Up and Down
buttons.
A digit that has been toggled disappears.
Finish the selection and press the OK button.
>>PRIME 1 INK COLOR
 PRINT HEAD : 1 3
Note
Do not select numbers of tubes that have not
been replaced as the pumps will run
unecessarily and ink will be wasted.
Install the jigs SINGLE COLOR FILLING TOOL(MV) for the selected colors and press the OK button.
(See 6.8.1 for how to use the SINGLE COLOR FILLING TOOL(MV).)
Check that a waste ink bottle is installed and press the OK button.
>>PRIME 1 INK COLOR
BOTTLE IS EMPTY?
Press the OK button after you have installed the jigs.
INSTALL
INK SUCTION TOOL
Press the OK button and open the ink box cover.
3-70
Chapter 3 Maintenance Mode Functions and Operations
◎
◎
◎
◎
XXXXXXX
◎
OKI Data Infotech Corporation CONFIDENTIAL