6.9.2
WIPE-SW-ASSY-MW and SWITCH(HVSENSOR)ASSY
<Removal>
1.
Remove the WIPING-UNIT-MW (see
6.9.1).
2.
Remove the WIPE-SW-ASSY-MW and
one securing screw.
3.
From the WIPE-SW-ASSY-MW, remove
the SWITCH(HVSENSOR)ASSY ond
one securing screw.
Notes for installation
Check that the terminal comes in contact
only when the HOLDER(BLADE-HV) turns
and presses the lever. If the switch does
not work like this, adjust the
SWITCH(HVSENSOR)ASSY angle.
When installing the WIPE-SW-ASSY-MW,
check that the two protrusions enter the
holes next to the screw before securing the
part.
Check that the extremity of the
SWITCH(HVSENSOR)ASSY is not open.
When installing the
SWITCH(HVSENSOR)ASSY, adjust the
position so that its terminal extremity gets
close to the lever.
6-90
OKI Data Infotech Corporation CONFIDENTIAL
Chapter 6 Parts Replacement (Disassembly/Reassembly)
Securing screw
Lever
WIPE-SW-ASSY-MW
Protrusions
WIPE-SW-ASSY-MW
SWITCH(HVSENSOR)ASSY