Media-Related Messages - Oki IP-6620 Maintenance Manual

5.3.4

Media-related messages

LIFT THE LEVER AND
LOAD THE MEDIA
<Description>
The media feed sensor has turned off, or the both the media feed and media output sensors have
turned on.
<Action>
Solve the problem, following the instruction in the message displayed.
If the error persists, check the Items to be Checked on the table below, and perform the actions
starting from the top until the problem is solved.
No
Rear-side media condition
1
Paper guide
2
Roll end switch
3
Media feed sensor and media
4
output sensor
PCB-ASSY-ACT3
5
PCB-ASSY-IPB5-100
6
LOAD MEDIA
<Description>
The media feed sensor is turned off, or the both the media feed and media output sensors are
turned off.
<Action>
Follow the instruction in the message displayed.
If the problem is not solved, perform the same actions as with LIFT THE LEVER AND LOAD THE
MEDIA until the problem is solved.
Chapter 5 Troubleshooting (Engine Section and USB Controller Section)
Items to be Checked
OKI Data Infotech Corporation CONFIDENTIAL
The media edge may not be detected when the condition is
as follows.
- Black-surface media; or
- Matte media.
Try another media.
Check that the media feed sensor and the media output
sensor are not covered with the paper guide.
Replace the switch.
Replace the sensors.
Replace the PCB-ASSY-ACT3.
Replace the PCB-ASSY-IPB5-100.
Action
5-37