Oki IP-6620 Maintenance Manual page 17

Name
Fan-shaped tension gauge (0.1 to 20 N)
Double-side type
(Oba keiki seisakusho)
BeltTension-Jig
Round-type spring tension gauge (50 N)
BLOCK-ADJUST-CR
BAR-ADJUST-CR
ADJUST HEAD PIN, MW
WIPING HEIGHT TOOL, MW
SINGLE COLOR FILLING TOOL (MV)
CAPPING-SEAL-TOOL (HV)
Name
Grease for synchro belt and
decelerating belt
Glove or fingerstall
Cleaning paper
Ethanol
Cap cleaning liquid
Wiper cleaning liquid
Cleaning swab
Dropper
Cleaning liquid cartridge
Storage liquid cartridge
Table 1-2 Jigs
Quantity
1 For X motor installation
1 For adjusting SUS belt tension (push)
1 For adjusting Y motor belt tension (pull)
4 - For adjusting the carriage height
- For adjusting the carriage parallelism
1 Head positioning pin
1 For adjusting the print heads inclination
1 For adjusting the wiping unit height
1 For supplying or draining one ink color
1 For checking leak tightness of the capping unit
Table 1-3 Consumables
Quantity
1 Grease EM-60L (Dow Corning Toray Co.,Ltd.)
or an equivalent grease (silicon grease can be
used)
1 pair For protection from ink blot, commercially
available
As required For wiping ink blot, Kimwipes or equivalent
As required For cleaning contacts, etc.
1 set Daily maintenance kit
1 set Daily maintenance kit
1 set Daily maintenance kit
1 set Daily maintenance kit
6 or 7 The number of necessary cartridges depends
on the number of ink colors
6 or 7 The number of necessary cartridges depends
on the number of ink colors
OKI Data Infotech Corporation CONFIDENTIAL
Chapter 1 Overview of Maintenance Workflow
Remarks
Remarks
1-3