11.
With the Up, Down, Left, and Right
buttons, add or remove the size of the
gap written down before to/from the
current adjustment value.
Example: If the current value is +1.1 mm
and the gap is +0.2 mm, then enter +1.3
mm as the new value.
Note
Do not change the value if the position was
correct.
(1) If the value has been changed in
step 11, check the wiping position
with the procedure below.
Example: If +1.1 has been changed
to +1.3.
If the value has not been changed,
go to the step (2).
(a) Enter the new value and press
the OK key. Then the carriage
moves to the wiping position for
the print head that has been
adjusted, and stops with the third
wiper blade turned upward
(configuration of step 8).
(b) When the adjustment value is
correct, press the OK key.
(c) Press the OK key to finish the
procedure.
(d) Press the CANCEL key to
perform the procedure again
from step 8.
(2) If the value has not been changed in
step 11, the message to the right
appears.
(3) Press the OK key to finish the
procedure.
OKI Data Infotech Corporation CONFIDENTIAL
ADJUST ONE COLOR
Lc:+ X.X +Y.Y
ADJUST ONE COLOR
Lc:+1.1 +1.3
CHECK WIPING POS
OK?
ADJUST ONE COLOR
Lc:+1.3 +1.3
WIPING POS CORRECT?
OK/CANCEL
>>>ADJUST FOR 1 COLOR
Lc
CHECK WIPING POS
OK?
END ADJ OPERATION?
OK/CANCEL
>>>ADJUST FOR 1 COLOR
Lc
Chapter 7 Adjustment
◎
◎
◎
◎
◎
◎
◎
◎
◎
7-25