Oki IP-6620 Maintenance Manual page 275

5.5.34 System Error 235X: Remaining Ink Sensor Error (LCIS model)
<Description>
The remaining sensor value is 8 kg or higher.
X
0
1
2
3
4
5
6
<Faulty part>
(1) PTM-ASSY(LCIS)
(2) CABLE(LCISWei-Sen)-ASSY(MW)
(3) CABLE(LCISWei-Sen-IF)-ASSY(MW)
<Action>
Check the Items to be Checked on the table below, and perform the actions starting from the top
until the problem of the remaining ink sensor that caused the error is solved.
No
1 Reservoir tray condition
2 Weight sensor
3 Harness condition
5-116
Chapter 5 Troubleshooting (Engine Section and USB Controller Section)
Sensor No.
No.1
No.2
No.3
No.4
No.5
No.6
No.7
Items to be Checked
OKI Data Infotech Corporation CONFIDENTIAL
Check that the reservoir tray is not stuck.
Check that there is no ink on the weight sensor.
Check that the weight sensor operates by moving the
reservoir tray up and down.
Replace the weight sensor if a problem is found.
Check that the connector is in contact when the drawer is
closed.
Replace the harness if a problem is found.
Action