5.9.2
IC (EEPROM)
<Removal>
To remove the IC(EEPROM) on the PCB-ASSY-IPB5-100, insert a flat-head precision
screwdriver under it.
Notes
Confirm that the power has been turned off before replacing the EEPROM.
Take measures against static electricity.
Pay attention not to bend the legs of the EEPROM when removing it.
Pay attention to the position of the pin 1 when installing the EEPROM.
The indentation on the pin 1 side should be placed on the right side. If the orientation of the
EEPROM is wrong, it will break when turning the printer on.
See 6.7.1 PCB-ASSY-IPB5-100 and PCB-ASSY-ACT3 when replacing the IC(EEPROM).
5-170
Chapter 5 Troubleshooting (Engine Section and USB Controller Section)
IC(EEPROM)
OKI Data Infotech Corporation CONFIDENTIAL
PCB-ASSY-IPB5-100