Oki IP-6620 Maintenance Manual page 511

(5) Press the OK button to adjust the
sensor, or the CANCEL button to
interrupt the operation.
(When you have pressed the OK button)
(When the procedure finishes normally)
The buzzer sounds once and the
following message is displayed.
Note
Write the adjustment values A and B on the label for remaining ink sensor replacement (small),
and paste the label to the corresponding color on the large label.
(6) After writing the adjustment values,
press the OK button.
(When the procedure finishes with an error)
The buzzer sounds three times and one
of the following messages is displayed.
When the drawer is open
When an error has been detected in the
adjustment results
* An error occurs if the remaining ink
sensor has not been replaced correctly.
After the error occurrence, press the OK
button to return to the first panel display
of the adjustment procedure.
After the adjustment is complete, open the drawer and remove the WEIGHT(1000) placed in step
11 .
7-36
OKI Data Infotech Corporation CONFIDENTIAL
EXECUTING...
PLEASE WAIT
ADJUST COMPLETE
CC A: X.XX B: Y.YY
CC: Ink color
X.XX: Adjustment value A (after adjustment)
Y.YY: Adjustment value B (after adjustment)
>>> POST-REPLAC ADJ
↕ CC A: X.XX B: Y.YY
CLOSE THE DRAWER AND
ADJUST SENSOR AGAIN
ABNORMALITY OCCURRED
CHECK NEW SENSOR
>>> POST-REPLAC ADJ
↕ CC A: X.XX B: Y.YY
Chapter 7 Adjustment
◎
◎
◎
◎