Oki IP-6620 Maintenance Manual page 177

Panel Message
PRIME INK SYSTEM
<Errors related to the waste ink bottle>
Panel Message
INSTALL
WASTE INK BOTTLE
REPLACE
WASTE INK BOTTLE
5-18
Chapter 5 Troubleshooting (Engine Section and USB Controller Section)
Error Description User Solution
The ink system is not Restart the printer.
primed.
Error Description User Solution
No waste ink bottle is - Reinstall the waste
installed. ink bottle.
- Restart the printer.
The waste ink bottle is - Check the waste
full. ink inside the
waste ink bottle.
- Reset the waste
ink counter.
- Restart the printer.
OKI Data Infotech Corporation CONFIDENTIAL
Service Engineer Inspection
(For inspection criteria, see
Reference to Check/Replace
Parts.)
- Install the last firmware version.
- Enter the maintenance mode
and check that INK SYSTEM
STATUS in the SYSTEM menu
is PRIMED.
Service Engineer Inspection
(For inspection criteria, see
Reference to Check/Replace
Parts.)
- Check that the MICRO SWITCH
4 (WASTEINK BOTTLE ASSY)
is not missing.
- Check that the MICRO SWITCH
4 connector is connected
correctly.
- In the CHECK SENSORS menu,
select WASTE BOTTLE and
execute INSTALLED, and check
the MICRO SWITCH 4
operation.
- Check that the CN22 connector
on the PCB-ASSY-ACT3 is
connected correctly.
- Check that the connector
between the
CABLE(TU-SENS1)-ASSY(MW)
and the
CABLE(TU-SENS2)-ASSY(MW)
is connected correctly.
Install the last firmware version.
Reference to
Assumed
Check/Replace
Replacement Part
Parts
- Firmware version
- PCB-ASSY-IPB5-100
- EEPROM
Reference to
Assumed
Check/Replace
Replacement Part
Parts
- MICRO SWITCH 4
- PCB-ASSY-ACT3
- PCB-ASSY-IPB5-100
- CABLE(TU-SENS1)-
ASSY(MW)
- CABLE(TU-SENS2)-
ASSY(MW)
- Firmware version
- PCB-ASSY-IPB5-100
- EEPROM