Oki IP-6620 Maintenance Manual page 198

MEDIA HAS SKEWED
ALIGN MEDIA
<Description>
With the skew check after the media installation, 100-mm media was fed, and, the media edge
was misaligned by ±2 mm or more.
<Action>
Re-install the media.
If the error persists after re-installing the media, check the Items to be Checked on the table
below,, and perform the actions starting from the top until the problem is solved.
No Items to be Checked
1 Media surface condition
2 Non-reflecting tape condition on
the platen
3 SENSOR(EDGE)MAINTENANCE
MEDIA HAS SKEWED
ALIGN MEDIA
<Description>
It has been detected that the media edges are misaligned by 3 mm or more due to a media skew.
<Action>
Reinstall the media.
If the problem is not solved even after reinstalling the media, perform the same actions as with
MEDIA HAS SKEWED ALIGN MEDIA.
OKI Data Infotech Corporation CONFIDENTIAL
Chapter 5 Troubleshooting (Engine Section and USB Controller Section)
The media edge may not be detected when the
condition is as follows.
- Black-surface media; or
- Matte media.
Try another media.
Check that the tape is not smeared. If it is, softly wipe
it with a soft cloth or lint-free paper dampened with
wiper cleaning liquid or cap cleaning liquid.
Check that the harness connector is securely
connected to the board's connector.
Remove the sensor, softly wipe it with a soft cloth or
lint-free paper dampened with ethanol, and
re-connect it.
If the error persists, replace the sensor.
Action
5-39