Oki IP-6620 Maintenance Manual page 312

No Items to be Checked
5 FFC's connector connection
Robot cable's connector
6
connection
7 PCB-ASSY-HCB1M
8 INKJET HEAD,MW (print head)
9 PCB-ASSY-IPB5-100
10 FFC
11 Robot cable
OKI Data Infotech Corporation CONFIDENTIAL
Chapter 5 Troubleshooting (Engine Section and USB Controller Section)
Reconnect the FFC on both the PCB-ASSY-HCB1M side
and the PCB-ASSY-IPB5-100 side.
If the cable terminals are smeared, softly wipe them with a
soft cloth or lint-free paper dampened with ethanol before
connecting them.
Reconnect the robot cable on both the PCB-ASSY-HCB1M
side and PCB-ASSY-ACT3 side.
Before connecting, check that the connector terminals and
cable connection part are not disconnected. If a connection
failure is found, replace the robot cable.
Replace the PCB-ASSY-HCB1M.
Replace the defective print head.
Replace the PCB-ASSY-IPB5-100.
Replace all four FFCs.
Replace the robot cable.
Action
5-153