Page 224 of 408
Installing and connecting SDI and ethernet ports
Terminal setup
553-3021-210
Standard 7.00
The terminal can be setup at any time, but it is not recommended that you do
so during data transmission to avoid potential data loss.
Setup values are given in Table 34 on page 225, Table 35 on page 226 and
Table 36 on page 227. Use the following procedure to set up the terminal.
Procedure 36
Setting up the terminal
1
Turn on the power for the terminal.
2
Enter setup mode by pressing the <SETUP> key located on the
top row of the special function keys.
The current setup values are displayed.
3
Change the value in each field on each setup screen as
necessary.
Use the following keys to view and change setup values:
Table 33
Setup (keys and functions)
Key
Arrow key
<Enter>
<Next Screen>
<Prev Screen>
4
Save changes by returning to the General setup screen, moving
the cursor to the Saved field, and pressing <Enter>.
January 2002
Function
Move from field to field
Scroll through possible values or cause
requested action to take place (depends on
type of field)
Move to next setup screen
Move back to last screen