Nortel Meridian 1 Option 11C Planning And Installation Manual page 304

Page 304 of 408 Connecting the trunks
553-3021-210 Standard 7.00
4 Select "1 ADD TRUNK" by entering the number "1".
The prompt "ROUTE ACCESS?" appears on the character display.
5 Enter the access code of the route to which you want to add a
trunk and press the pound key (#).
The prompt
"TN?"
asks you to enter a TN (Terminal Number) from one of the installed
trunk cards.
If you do not enter a valid route number, "TN?" does not appear and
the screen remains the same. If the type of trunk card does not match
the route, the prompt "ROUTE ACCESS?" appears again, and you
hear overflow tone.
6 Enter the TN in Option 11 format (CCUU) and press the pound
key.
The prompt
"MODEL"
appears. If you enter an invalid TN, the display shows "INVALID, TN?"
and you must enter a new TN using the Option 11 format.
7 Press the digits to select a trunk model (as assigned in LD 16).
The character display shows
"OK".
After a delay of approximately 4 seconds you hear special dial tone.
The sequence is repeated when the prompt
"TN?"
appears on the character display.
The next valid trunk TN is automatically incremented after each trunk
is activated.
8 Terminate the sequence by hanging up the telephone receiver, or
Repeat the sequence by going through the steps again.
By entering "#" when the procedure repeats, you accept the next TN
and are prompted for the model type.
By entering "#" again, you accept the previously accepted model.
Note: The model chosen during the first trunk activation sequence will
be the default model for all subsequent trunks until you hang up the
telephone or manually enter a new trunk model number.
January 2002