Nortel Meridian 1 Option 11C Planning And Installation Manual page 156

Page 156 of 408 Installing System Controller Cards
553-3021-210 Standard 7.00
Procedure 15
Installing the Dual Port Fiber Expansion daughterboards on the SSC
card.
1 Put on the anti-static wrist strap.
2 Place the SSC card on a clean flat surface.
3 Install the Fiber Daughterboards for expansion cabinet 1 and 3 on
the connector as shown in Figure 65 on page 158 (the upper
connector).
4 Install the Fiber Daughterboard for expansion cabinet 2 and 4 on
the connector as shown in Figure 65 on page 158 (the lower
connector).
5 Connect the faceplate LED to the 3 pin header on the
daughterboard. See Figure 65 on page 158.
6 Press firmly on the standoffs to ensure that the cards are secured
to the SSC.
7 Route the cables through the SSC cable router on the SSC card.
Refer to Figure 67 on page 161.
8 Insert the NDK20 SSC card into slot "0" of the main Option 11C
cabinet.
9 Route the fiber cable through the Cable Routing Guide under the
main cabinet.
Note: Be sure to wrap the cable a minimum of one complete loop
around the Cable Routing Guide to allow extra cable for removing the
SSC card later.
January 2002