Nortel Meridian 1 Option 11C Planning And Installation Manual page 245

1. Automatically Using BootP
2. Using Manual Configuration
3. Keep Existing Configuration
[q]uit, [p]revious, [m]ain menu, [h]elp or [?], <cr>
- redisplay
Enter Selection: 2
3 Configure IP Expansion Parameters.
For the following menu, the sample IP parameters will be used:
IP address of the expansion cabinet 100BaseT(F): 47.147.20.101;
Subnet Mask of the expansion cabinet 100BaseT(F): 255.255.255.0;
Gateway address: 47.147.20.1;
IP address of the main cabinet 100BaseT(F): 47.147.10.100.
The IP Parameters menu is displayed:
Enter Expansion New IP Parameters:
Expansion IP: 47.147.20.101
Expansion NetMask: 255.255.255.0
Main IP: 47.147.10.100
Expansion Router/Gateway: 47.147.20.1
Is this correct? (t/n/[a]bort): Y
Note: 'Expansion Router/Gateway' appears only in a Layer 3
configuration.
4 The software installation is completed automatically without user
intervention.
5 Refer to Software Input/Output Guide Maintenance (553-3001-511)
LD 117 to configure the IP Expansion cabinets IP Address.
—————————— End of Procedure ——————————
System software installation Page 245 of 408
Option 11C Planning and Installation Guide