Nortel Meridian 1 Option 11C Planning And Installation Manual page 305

Activating a selected model trunk
Due to the automatic thirty second time-out on the administration menu, be
sure that you have prepared the data that you want to input before you begin.
To determine corresponding TNs and trunks, check the location of trunk
cards in the cabinet or use LD 32.
Procedure 52
Activating a selected model trunk
1 Pick up the handset of the administration telephone.
2 Enter the administration Flexible Feature Code to access the
administration menu.
3 Enter the default administration telephone password.
You hear special dial tone and the prompt "TASK?" appears on the top
line of the character display. The second line of the character display
reads "1 ADD TRUNK".
4 Select "1 ADD TRUNK" by entering the number "1".
The prompt
"ROUTE ACCESS?"
appears.
5 Enter the access code of the configured trunk route to which you
want to add the trunk and press the pound key (#).
The prompt
"TN?"
asks you to enter a TN from one of the installed trunk cards. If you do
not enter a valid route number, "TN?" does not appear and the screen
remains the same. If the card does not match the route, the prompt
"ROUTE ACCESS?" appears again, and you hear overflow tone.
6 Enter the TN in Option 11 format (CCUU).
The response
"MODEL?"
prompts you to select a model number for the trunk.
7 Enter a trunk model number for the specified TN and route and
press the pound key.
The character display shows:
"OK"
Connecting the trunks Page 305 of 408
Option 11C Planning and Installation Guide