Installing The Krone Test Jack Frame For The Uk - Nortel Meridian 1 Option 11C Planning And Installation Manual

Installing and connecting cross-connect terminals to cabinets Page 175 of 408

Installing the Krone Test Jack Frame for the UK

Procedure 21 describes how to install the Krone Test Jack Frame
Procedure 21
Installing the KroneTest Jack Frame
1 Consult the equipment layout plan to determine where the
cross-connect terminal should be located. Refer to "System and
site requirements" on page 35.
the terminal blocks in a layout similar to that shown
2 Install
in
Figure 74 on page 176.
3 Attach labels on the cross-connect terminal to indicate the
terminal blocks assigned to:
• AUX wiring
• Power fail transfer units
• Telephones and consoles
• Analogue line cards
• DC5/AC15/RAN/PAG cards
• Data Access Cards
• Digital line cards
• Exchange line trunk cards
• Direct Dialing Inward trunk cards
• other miscellaneous equipment
Option 11C Planning and Installation Guide