Activating A Customized Model Without A Character Display - Nortel Meridian 1 Option 11C Planning And Installation Manual

Activating a customized model without a character display

Procedure 48
Activating a customized telephone
1 Plug the telephone set into the jack and wait 20 seconds before
picking up the handset. If you do not receive dial tone, replace the
handset and wait another 10 seconds before going off-hook
again. Repeat this procedure until dial tone is received.
Note: The 20 second time interval is required for the system to
determine whether the set is new or if it is being relocated using the
Modular Telephone Relocation feature.
2 Press the digits associated with the customized model and press
the pound key (#).
Dial tone disappears after the first digit is pressed, and you hear three
beeps followed by continuous dial tone (special dial tone) after you
press the pound key.
3 Enter the customized extension number and press the pound
key.
You hear a short high-pitched beep lasting four seconds, followed by
silence (relocation tone).
If the extension number is already in use by another telephone, you
hear special dial tone again.
If the extension number is not available for use, you hear a fast,
high-pitched broken tone (overflow tone), and you must repeat this
step.
4 Hang up the telephone handset.
After approximately 10 seconds, the telephone is configured.
Note: If other keys require secondary extension numbers, you are
prompted until you enter all of the required extension numbers for the
model. These extension numbers cannot be defaulted. You are
prompted for each additional extension number with three beeps
followed by continuous dial tone (special dial tone). When you are
programming an extension number, the lamp associated with that
number on the telephone is lit.
Connecting the telephones Page 275 of 408
Option 11C Planning and Installation Guide