Printing Model Information; Changing A Route Access Code - Nortel Meridian 1 Option 11C Planning And Installation Manual

Printing model information

Changing a route access code

CUST 0
MODL YYY "YYY" = the model number associated
with the trunk type you are removing
(Valid range is 1-127).
To print information about model trunks, load LD 20 and type in the
following commands on the TTY:
LD 20
REQ PRT
TYPE TTTT M "TTTT" = the trunk type
MODL YYY "YYY" = the model number. If you want to print all of the
models for this trunk type, leave this value blank.
Use this procedure to change a route access code.
Procedure 57
Changing a route access code
1 Pick up the handset of the administration telephone.
2 Enter the administration Flexible Feature Code to access the
administration menu. (For some countries, this value is listed in
"Flexible Feature Codes" on page 324.)
3 Enter the default administration telephone password. (For some
countries, this value is listed in "Passwords and codes" on
page 315.)
Changing pre-programmed data Page 403 of 408
Option 11C Planning and Installation Guide