Installing The Reichle Masari Cross-Connect Terminal (Germany) - Nortel Meridian 1 Option 11C Planning And Installation Manual

Installing and connecting cross-connect terminals to cabinets Page 173 of 408
Installing the Reichle Masari cross-connect terminal
(Germany)
Procedure 20 describes how to install the
terminal.
Procedure 20
Installing the Reichle Masari cross-connect terminal
1 Consult the equipment layout plan to determine where the
cross-connect terminal should be located. Refer to "System and
site requirements" on page 35.
the terminal blocks in a layout similar to that shown
2 Install
in
Figure 73 on page 174.
3 Attach labels on the cross-connect terminal to indicate the
terminal blocks assigned to:
• 25-pair cables from the cabinets
• AUX wiring
• Power fail transfer units
• Telephones and consoles
• Trunks
• Analogue line cards)
• DC5/AC15/RAN/PAG cards
• Data Access Cards
• Digital line cards
• Exchange line trunk cards
• Direct Dialing Inward trunk cards
• other miscellaneous equipment
4 Ground the cross-connect terminal
Connect a 16 mm
ground wire from the ground bar on the cross-connect terminal to the
ground lug in each cabinet.
Reichle Masari
2 2
(10 mm green-yellow ground wire for Germany)
Option 11C
cross-connect
Planning and Installation Guide