Nortel Meridian 1 Option 11C Planning And Installation Manual page 235

• Validate keycodes
• Set the system time and date
• Reboot the Main cabinet
• Wait for link to come up.
Note: IP expansion cabinet software must be the same software
version as the main Option 11C cabinet.
Wear the antistatic wrist strap provided in the bottom of the
cabinet before handling circuit cards. Static electricity can
damage the components of power supplies and circuit cards.
Procedure 38
Installing the software
Note: This procedure assumes that the system installation
procedures in Chapter 8 have been performed and that the system is
up and running. The Link LED on the software daughterboards should
be lit and green.
1 Observe the terminal screen.
If the following is displayed:
SOFTWARE INSTALLATION PROGRAM
proceed to Step 3.
If the following is displayed:
current system time and date: 00:00:00 -- 00/00/00
proceed to Step 2.
If neither message appears, refer to the Option 11C and 11C Mini Fault
Clearing (553-3011-500).
2 Set the system time and date.
System software installation Page 235 of 408
CAUTION
Option 11C Planning and Installation Guide