Nortel Meridian 1 Option 11C Planning And Installation Manual page 16

Page 16 of 408 Equipment identification
Cabinets
553-3021-210 Standard 7.00
The NTAK11 Cabinet is used for both main and expansion cabinets. The
cabinet faceplate has been updated for Release 25.2x.
Figure 1
NTAK11 Cabinet
Cable connectors
Connectors for cables to the cross-connect terminal and SDI ports are found
at the bottom of each cabinet.
The AUX, SDI and Ethernet connectors are located at the bottom left-hand
side of the cabinets. The AUX port connects auxiliary equipment such as a
Power fail transfer unit (PFTU) to the Option 11C in each cabinet. The SDI
connector in the main and IP expansion cabinets interfaces three SDI ports
using a three-port SDI cable. The Ethernet connector in the main cabinet
provides a 10 Mbps Ethernet port.
January 2002