Activating A Default Model Without A Character Display - Nortel Meridian 1 Option 11C Planning And Installation Manual

Page 272 of 408 Connecting the telephones

Activating a default model without a character display

553-3021-210 Standard 7.00
Note 3: Each prompt for another extension number is accompanied
by special dial tone. When you are programming an extension number,
the lamp associated with that number on the telephone is lit.
4 Hang up the telephone receiver.
After approximately 10 seconds, the telephone is configured.
Note: If you replace the handset before completing the prompt
sequence, the installation will automatically fail. This can be useful if
you make an error and want to restart the procedure.
Procedure 46
Activating the telephone
1 Plug the telephone set into the jack and wait 20 seconds before
picking up the handset. If you do not receive dial tone, replace the
handset and wait another 10 seconds before going off-hook
again. Repeat this procedure until dial tone is received.
Note: The 20 second time interval is required for the system to
determine whether the set is new or if it is being relocated using the
Modular Telephone Relocation feature.
2 Press the pound key (#) to select the default model.
3 Press the pound key again to select the default extension
number.
You hear a short, high-pitched beep lasting four seconds followed by
silence (relocation tone).
Note: If the extension number is already in use by another telephone,
you hear three beeps followed by continuous dial tone (special dial
tone).
To accept the default extension number press the pound key.
To select a new extension number, manually enter an extension
number and press the pound key.
January 2002