Nortel Meridian 1 Option 11C Planning And Installation Manual page 404

Page 404 of 408 Changing pre-programmed data
553-3021-210 Standard 7.00
You hear special dial tone and the prompt
"TASK?"
appears on the top line of the character display. If you press the
asterisk, "2 CHANGE ROUTE ACCESS" appears on the second line
of the character display.
4 Select "2 CHANGE ROUTE ACCESS" by entering the
number "2".
The prompt
"ROUTE ACCESS?"
appears on the character display.
5 Enter the access code of the route to be modified and press the
pound key (#).
The prompt
"NEW ACCESS CODE?"
asks you for a new access code for the route.
6 Enter the new access code and press the pound key.
The display shows
"CODE CHANGED".
After a delay of approximately 4 seconds you hear special dial tone
and the sequence is repeated when the prompt
"ROUTE ACCESS?"
appears.
OR
If the route access code is not available for use, you hear overflow
tone.
The display shows
"USED, ROUTE ACCESS?"
and you must repeat this step.
You must enter a different access code. This sequence continues
until you enter an appropriate new access code.
7 Terminate the sequence by hanging up the telephone, or
Repeat the sequence by going through the steps again.
January 2002