ADAN OUT TTY X "X" = the TTY that you are removing.
Interference with the SPRE code
If the pre-programmed SPRE code interferes with the programming required
for the Option 11 system, use LD 15 to remove it. (For some countries, the
default SPRE access code is listed in "First digits" on page 316.) For
customer 0 enter the following in response to the SPRE prompt:
LD 15
SPRE Xy "y" = the value of the SPRE code
Note: To define a new SPRE code, type a space and enter the new
number.
Interference with the attendant extension number
You cannot remove the attendant extension number entirely from the
Option 11 system data; you can only replace it with another number.
LD 15
REQCHGCHG = Change
TYPECDBCDB = Customer Data Block
CUST x "x" = Customer number
.
ATDN xxxx "xxxx" = the new extension number
Changing or removing the pre-programmed night number
For some countries, the default value of the night number is listed in
"Important extension numbers" on page 318. If you wish to change or remove
the night number, use LD 15.
LD 15
REQ CHG CHG = Change
TYPE CDB CDB = Customer Data Block
CUST x "x" = Customer number
Changing pre-programmed data Page 395 of 408
Option 11C
Planning and Installation Guide