Nt8D14 Universal Trunk Card - Nortel Meridian 1 Option 11C Planning And Installation Manual

NT8D14 Universal Trunk card

Table 22
NT8D14 Universal trunk — modes and option settings (Part 1 of 2)
Central (CO)
2-way tie trunk (loop Dial Repeat)
2-way tie trunk (Outgoing Incoming Dial)
Recorded Announcement (RAN)
Paging trunk
Japan CO/DID operation
Procedure 25
NTAK03 card installation
1 Insert the card in its assigned slot.
The NTAK03 TDS/DTR card may be inserted into any of the card slots
1 through 9.
2 Connect an NTAK19EC cable (or an NE-A25-B cable) from the
corresponding connector at the bottom of the cabinet. If you are
using an NE-A25-B cable, terminate it at the cross-connect terminal
(since the NTAK19EC cable is equipped with connectors, it does not
require termination at the cross-connect terminal).
The universal trunk card provides eight analog trunks which can function in
the modes shown in the following table.
This line card can be installed in slots 1 through 10 in the main cabinet or 11
through 30 in the expansion cabinets.
Procedure 26
Universal Trunk card installation
1 Set the jumpers for the NT8D14 Universal Trunk circuit card
according to the following table.
Modes
Installing the circuit cards Page 191 of 408
Location
J1, J2
J1, J2
J1, J2
J1, J2
J1, J2
J1, J2
Option 11C Planning and Installation Guide
Jumper
strap
OFF
OFF
OFF
OFF
OFF
OFF