ascom
Ascotel 2025/2045/2065
&A
Look Show HO
&A
Show HO : None
Ok
&A
Show HO : Beep
Ok
&A
Show HO : Disp
Ok
&A
Show HO : Both
Ok
Fig. 3.33:
Selection of the handover display for Look mode and Normal mode
3.68
Planning DECT Systems
For look mode and normal mode a selection
can be made as to whether handovers are
to be displayed.
The beep setting specifies that each handover
is acoustically indicated by a beep tone:
high-pitched tone for connection HO to a new
radio unit, low-pitched tone for bearer HO to
the same radio unit.
The beep is output only in normal mode.
The "Disp" setting specifies that each handover
⇓
in normal mode is indicated on the display.
1010 0 17 32
⇓
1010 0 18 59
⇓
⇓
haz1303aaena0
Before the HO:
i
M
The bar indicates that the signal
strength of the current radio unit
##
(No. 17) is bad and that HO should
be attempted.
HA attempts HO connection to a
new radio unit (No. 18).
After the HO:
i
M
The bar indicates that the signal strength
is very good. The new radio unit No. is
####
visible in the display (No. 18).
HBT_20321104_03/B0_en