ascom
Ascotel 2025/2045/2065
Fit the EIM Card
1. Fit a new EIM card
2. Close the chip-card housing (slide the lock toward "LOCK")
3. Press the Prog. pushbutton (see Fig. 7.1 and Fig. 7.2)
4. Mounting the PBX housing cover
5. After the system has been started up, log on all handsets again. This is neces-
sary because the DECT identification numbers are stored on the EIM card.
Note:
The EIM card must be fitted before the system is put into operation. The
PBX will not start without the EIM card.
7.24
Hardware Updates and System Expansion
HBT_20321104_07/B0_en