ASCOM Ascotel 2025 System Manual page 987

ascom Ascotel 2025/2045/2065
1. In PINX 1, only allocate to the route pointing to PINX 2 the trunk group con-
taining the lines to be tested (e.g. trunk group 5).
2. Move all the network interfaces in trunk group 5 - bar one - to another, empty
trunk group (in this example trunk group 20).
3. Call a subscriber on PINX 2.
4. Move the tested network interface to trunk group 20.
5. Move the next network interface to be tested from trunk group 20 to trunk
group 5.
6. Repeat steps 3 to 5 until all the lines have been tested.
7. Move all the network interfaces back into trunk group 5.
8. Repeat the procedure for all trunk groups with lines to PINX 2.
9. Allocate all the trunk groups back to the route.
Repeat steps 1 to 9 for all PINXs.
Function Test for PISN – Internal Traffic
1. Set up at least one connection to each PINX.
2. Check the ringing pattern.
3. Check the display on the terminal.
Testing the Overflow Routing from PINX 1 to PINX 2 via PINX 3 and PINX 4.
1. In PINX 1, assign to the route pointing to PINX 2 (route 5 in the example here)
only the trunk group with the lines to be tested (trunk group 6 in the example
here).
2. Call a subscriber on PINX 2.
3. Allocate all the trunk groups back to the route.
4. Repeat steps 1 to 3 with all the PINXs.
6.14 Function Check HBT_20321104_06/B0_en