Specifying the Numbering Plan Identifier NPI and the Type of Number
TON
The call number of an outgoing call is assigned the NPI defined under "Number-
ing plan identifier NPI".
• For routes that are used for routing outgoing calls whose end destination is in
the public network, set "E.164".
• For routes that are used for routing outgoing calls via dedicated lines with end
destination in the PISN, set "PNP".
"TON = unknown" is always assigned as the type of number.
Send Delay
Send delay is used to specify how many digits need to be dialled before a call is
set up. The idle tone will be injected by the PBX as long as the line is not seized.
This setting is useful in the following situations::
• When calls are routed to the public network via third-party PINXs
• When the destination PBX can only evaluate whole call numbers (Overlap
Receiving not supported)
• To save line resources under heavy traffic conditions
Other Subjects Related to Routes:
Trunk group, Call distribution, Subscriber configuration, Operator Con-
soles, key telephone, Outgoing traffic, Least Cost Routing, Traffic in the
PISN, Numbering plan.
HBT_20321104_02/B0_en
ascom
Ascotel 2025/2045/2065
Routing Elements
2.65