ascom
Ascotel 2025/2045/2065
8.1.2
Office 25, Office 35, Office 45
Installation
1. Set the AD2 bus address under the terminal's designation label.
– TSD1 = Address switch not pressed (disengaged)
– TSD2 = Address switch pressed (engaged)
2. Plug the coiled cable into the underside of the Office.
3. Feed the coiled cable through the strain relief.
4. Plug the coiled cable into the handset.
5. Plug the connecting cable to the terminal and feed it through the strain relief.
6. Plug the connecting cable into the socket.
7. If the system is configured, test the operation of the terminal.
8. Label the telephone.
AD2 Interface
Fig. 4.74:
Fit the connecting cable as shown in the example with the Office 45
Note:
The entire length of the cable from the PBX to the connection socket
and from the connection socket to the Office terminal should not
exceed 6 m.
4.108
Installing Terminals
haz1259aaena0
HBT_20321104_04/B0_en