Mitsubishi Electric MELSEC iQ-R Series User Manual page 562

Error Error
code (System/
(Hexad axis/axes
ecimal) group)
34FEH System
34FFH System
3500H System
3501H System
3502H System
3503H System
3504H System
3505H System
3506H System
3507H System
3508H System
3509H System
350AH System
22 TROUBLESHOOTING
560
22.5 List of Error Codes
Error name Error detail and cause
Label Temporary Area The secured label temporary
Exceeded area size exceeded its limit.
Operation Error Division where the divisor is zero
was performed.
Operation Error Incorrect data that cannot be
converted by using the data
conversion instruction was input.
Operation Error The operation was performed
with the invalid data (-0,
denormalized number, NaN (not
a number), or ).
Operation Error Overflow occurred during
calculation.
File Incorrect The program file is incorrect. Or,
not correctly write the program
file.
Insufficient Memory Failed to execute PSCAN/
Capacity PSTOP instruction because the
execution count of PSCAN/
PSTOP instruction in 1 scan is
too many.
Memory Error The memory jump destination is
out of the range for memory
assignment.
Device/Label • The device or label specified in
Specification Incorrect the instruction exceeded the
usable range.
• Insufficient number of array
elements.
Operation Error The data out of the specified
range was input.
Operation Error The operation result is out of the
output range. (When the result of
the instruction that concatenate
character strings exceeded the
allowable number of characters)
Program Name The program specified in the
Specification Incorrect instruction is not registered to the
program setting.
Program Error The program includes any
instruction that cannot be used or
decoded.
Detection Operation at
timing (At error
start/ occurrence
during
control
When The program stops.
executing
instruction
When Program stops/
executing continues.
instruction Follow the setting below.
Operation setting at
error: Operation error
When Program stops/
executing continues.
instruction Follow the setting below.
Operation setting at
error: Operation error
When Program stops/
executing continues.
instruction Follow the setting below.
Operation setting at
error: Operation error
When Program stops/
executing continues.
instruction Follow the setting below.
Operation setting at
error: Operation error
When Interrupts importing the
executing files.
instruction
When The program stops.
executing
instruction
When The program stops.
executing
instruction
When Program stops/
executing continues.
instruction Follow the setting below.
Operation setting at
error: Invalid device/
label/buffer memory
specification
When Stops/continues
executing Follow the setting below.
instruction Operation setting at
error: Operation error
When Stops/continues
executing Follow the setting below.
instruction Operation setting at
error: Operation error
During END Stops/continues
processing Follow the setting below.
Operation setting at
error: File name
specification
At ready ON The program stops.
Remedy
• Please increase the
capacity of label area.
• Please write the
program again.
Please check and
correct error occurrence
points.
Please check and
correct error occurrence
points.
Please check and
correct error occurrence
points.
Please check and
correct error occurrence
points.
Please write the
program again.
Please correct it so that
it does not execute
unnecessary PSCAN/
PSTOP instructions after
checking the error
occurrence points.
Please write the
program again.
Please check and
correct error occurrence
points.
Please check and
correct error occurrence
points.
Please check and
correct error occurrence
points.
Modify it to a correct
program name.
Please check the
corresponding program,
and correct it.