List Of Event Codes - Mitsubishi Electric MELSEC iQ-R Series User Manual

22.6

List of Event Codes

This section lists the events which occur in CC-Link IE TSN.
System, security, and operation are included in the event types.
System
Event code Overview
07EF Follow-up Temporarily Invalid Cancellation
07F0 MCFB Start (Control System)
07F1 MCFB Start (Operation System)
07F2 FB Start
07F3 MCFB Stop
07F4 File Transmission Start
07F5 Start when SW Stroke Limit is Disabled
07F6 Start when HW Stroke Limit is Invalid
07F7 Forced Stop Detection
07F8 Event History File Creation
07F9 OPR Request Clear
07FA Current Position Change
07FB Follow-up Temporary Invalid
07FC Servo ON when Follow-up is Invalid
07FD Current Position Restoration Completion
07FE OPR Request OFF to ON
Security
Event code Overview
10100 Security key Registration/Deletion
10200 Remote Password Lock
10201 Remote Password Unlock Successful
10202 Remote Password Unlock Failed
10300 Access from IP restricted with IP filter
setting
10400 File Password Registration/Change/
Deletion Successful
10401 File Password Registration/Change/
Deletion Failed
10402 File Password Clear Successful
10403 File Password Clear Failed
Cause
Follow-up invalid has been cancelled.
MCFB was started.
MCFB start or continuous start was executed.
FB was started.
MCFB was stopped by stop cause.
File transmission was started by script file/label.
Start when software stroke limit is invalid by
AxisName.Cd.SwStrokeLimit_Override.
Start when hardware stroke limit is invalid by
AxisName.Cd.HwStrokeLimit_Override.
Forced stop signal is detection status.
Event history file was created.
OPR request clear is ON.
Current position change was executed.
Follow-up was switched to invalid.
Change it to servo ON from follow-up disabled status of servo OFF.
Current position restoration was completed.
• OPR request is ON.
• Absolute position erase at driver side was detected. [Real drive axis only]
(Detail Code: 0)
• Absolute position data error in motion module was detected. (Detail Code : 1)
• Axis type was changed. (Detail Code: 2)
• 'Polarity(607Eh)' b7:position polarity of driver object was changed. (Detail
Code: 3)
• Change of driver or motor encoder was detected (Detail Code: 4)
• Machine OPR was started. (Detail Code: 5)
• Driver unit conversion (numerator/denominator) of axis was changed. (Detail
Code: 6)
• Machine OPR has never been executed after system started. (Detail Code: 7)
• Current position restoration was executed. (Detail Code: 7)
Cause
A security key was registered or deleted.
The lock processing for the remote password was performed.
The unlock processing for the remote password was completed successfully.
The unlock processing for the remote password was not completed successfully.
It was accessed from IP address restricted with the IP filter setting.
Registration, change, or deletion of a file password was performed and
completed successfully.
Registration, change, or deletion of a file password was performed and was not
completed successfully.
Clear of a file password was performed and completed successfully.
Clear of a file password was performed and was not completed successfully.
22 TROUBLESHOOTING
565
22.6 List of Event Codes
22