Mitsubishi Electric MELSEC iQ-R Series User Manual page 535

Warning Error Warning name
code (System/
(Hexade axis/axes
cimal) group)
0F08H System Cycle Over Warning
0F09H System File Transfer Execution
Request Acquisition
Disabled Warning
0F0AH System File Transfer Execution
State Update Disabled
Warning
0F0BH Axis Maximum Setting Axis
Number Over Warning
0F0CH System Warning Filter Set
Failed Warning
0F0DH System Program Setting Import
Disabled Warning
0F0EH System Module extended
parameter storage
location warning
*1 Note that the setting range of the upper limit value/lower limit value differs depending on the setting value of
"AxisName.PrConst.RingCount_Enable".
Error detail and cause Detection
timing (At
start/
during
control
Arithmetic processing or other During
fixed scan processing is not operation
completed within the set cycle.
Failed to get address of At system
"System.Cd.FileTransfer_Execut start
e".
Failed to get address of At system
"System.Md.FileTransfer_State". start
The axis setting which exceeded At ready
the maximum control axis ON
number exists.
• Addon MotionEventHist is At ready
disabled. ON
• The memory capacity of addon
MotionEventHist is insufficient.
Failed to import the program At ready
setting. ON
The project content of the Target At system
Folder, which differs from that of start
module extended parameter
storage location setting, was
changed.
Operation at Remedy
warning occurrence
Continues the operation. Please change the fixed
scan interval setting of
fixed scan execution
type program to a larger
value.
Please change the
followings to a lager
value.
• "System.PrConst.Syst
emBaseCycle.Cycle"
• "System.PrConst.Oper
ationCycle[1].Cycle"
• "System.PrConst.Buffe
rmemory_RefreshCycl
e.Cycle"
Cannot execute the file Start the system again.
transfer of the command
label.
Cannot execute the file Start the system again.
transfer of the command
label.
The axis which is greater Set the number of
than the mazimum setting axis within the
setting axis number is maximum number of
not recognized as the control axis.
axis. (Md is not updated)
Continues the operation Please check the
by disabling the filter set. memory capacity of
Addon MotionEventHist.
Enable addon
MotionEventHist.
The program setting is Please write the project
not imported. to user root path.
The written module Review the module
extended parameter is extended parameter
not enabled. storage location setting.
22 TROUBLESHOOTING
22.4 List of Warning Codes
22
533